Fog Nozzles Technical Information

FOG NOZZLE CHARACTERISTICS

SPRAY ANGLE:

Depending on pressure:
0.20mm 55-70deg.
0.30mm 65-75 deg.
0.40mm 80 deg.
0.50mm 80 deg.

MINIMUM PRESSURE REQUIRED:

0.20mm: 18 Kg /cm / 250 PSI+
0.30mm: 3 Kg /cm / 45 PSI+
0.40mm: 3 Kg /cm / 45 PSI+
0.50mm: 3 Kg / cm / 45 PSI+

SPRAY CHARACTERISTICS:

Produces a high percentage of less than 50 micron size droplets at higher pressure ranges.

SPRAY PATTERN:

Cone Shape

To calculate higher or lower flow rates from the table below. The following formula may be used.

TYPICAL FOG NOZZLE APPLICATIONS

	AVIARIES	X	X	X	X
	BARNS	X		X	X
	DAIRY	X		X	X
	HOGS	X	X	X	X
	HORSES	X		X	X
	KENNELS	X		X	X
	LIVESTOCK	X		X	X
	POULTRY	X		X	X
	ZOOS	X	X	X	X
	FLOWERS	X	X	X		X	X
	FOLIAR FEEDING		X				X
	GREENHOUSES	X	X	X			X
	HYDROPONICS	X	X	X			X
	ORCHARDS			X		X
	PLANTS	X	X	X		X
	PROPAGATION		X	X			X
	STORAGE	X	X	X	X
	TISSUE CULTURE						X
	VINEYARDS		X	X		X
	AMUSEMENT PARKS	X
	GOLF	X
	HOTELS	X
	LIVING AREAS	X
	RESTAURANTS	X
	SPECTATOR AREAS	X
	TENNIS COURTS	X
	AIR & GASES		X				X
	CIRCUIT BOARDS		X		X		X
	COILS	X
	COOLING TOWERS	X	X				X
	CONCRETE CURING		X				X
	CONSTRUCTION	X			X
	GINNING		X	X
	MINING	X	X		X
	ODOR CONTROL		X				X
	OUTDOOR WORK	X			X
	PAPER MAKING		X				X
	PLASTIC EXTRUSION	X					X
	POLLUTION CONTROL		X		X		X
	RADIATORS	X
	ROOFS	X
	SPINNING		X				X
	STORAGE	X	X	X	X
	TEXTILES		X				X

* Fog Nozzle flow rates tested with water under controlled laboratory conditions. Flow rates can vary due to environment, fluid viscosity and fluid density.

** Other sizes available on request.